Switch Configuration Command List
The following table lists common switch configuration commands:
Task | Command |
Move to interface configuration mode | switch(config)#interface FastEthernet 0/14 switch(config)#interface GigabitEthernet 0/1 |
Move to configuration mode for a range of interfaces | switch(config)#interface range fastethernet 0/14 - 24 switch(config)#interface range gigabitethernet 0/1 - 4 switch(config)#interface range fa 0/1 - 4 , 7 - 10 switch(config)#interface range fa 0/8 - 9 , gi 0/1 - 2 |
Set the port speed on the interface | switch(config-if)#speed 10 |
Set the duplex mode on the interface | switch(config-if)#duplex half |
Enable or disable the interface | switch(config-if)#no shutdown |
Show interface status of all ports | switch#show interface status |
Show line and protocol status of all ports | switch#show ip interface brief |
Be aware of the following switch configuration details:
- All switch ports are enabled (no shutdown) by default.
- Port numbering on some switches begins at 1, not 0. For example, FastEthernet 0/1 is the first FastEthernet port on a 2960 switch.
- Through auto-negotiation, the 10/100/1000 ports configure themselves to operate at the speed of attached devices. If the attached ports do not support auto-negotiation, you can explicitly set the speed and duplex parameters.
- If the speed and duplex settings are set to auto, the switch will use auto-MDIX to sense the cable type (crossover or straight-through) connected to the port and will automatically adapt itself to the cable type used. When you manually configure the speed or duplex setting, it disables auto-MDIX so you will need to be sure to use the correct cable.
- The 2960 switch always uses the store-and-forward switching method. On other switch models, you might be able to configure the switching method.
Tidak ada komentar:
Posting Komentar